$A$ current $I = 10 \ A$ is passed through the part of a circuit shown in the figure. What will be the potential difference between $A$ and $B$ when $I$ is decreased at a constant rate of $10^2 \ A \ s^{-1}$ (in $V$)?

$A$ circular insulated copper wire loop is twisted to form two loops of area $A$ and $2A$ as shown in the figure. At the point of crossing,the wires remain electrically insulated from each other. The entire loop lies in the plane of the paper. $A$ uniform magnetic field $\vec{B}$ points into the plane of the paper. At $t=0$,the loop starts rotating about the common diameter as an axis with a constant angular velocity $\omega$ in the magnetic field. Which of the following options is/are correct?
[$A$] The rate of change of the flux is maximum when the plane of the loops is perpendicular to the plane of the paper.
[$B$] The net emf induced due to both the loops is proportional to $\cos \omega t$.
[$C$] The emf induced in the loop is proportional to the sum of the areas of the two loops.
[$D$] The amplitude of the maximum net emf induced due to both the loops is equal to the amplitude of maximum emf induced in the smaller loop alone.

An electron moves along the line $AB$,which lies in the same plane as a circular loop of conducting wires as shown in the diagram. What will be the direction of current induced,if any,in the loop?

$A$ metallic ring with a small cut is held horizontally and a magnet is allowed to fall vertically through the ring. Then the acceleration of the magnet is:

The adjoining figure shows two different arrangements in which two square wire frames are placed in a uniform constantly decreasing magnetic field $B.$ If $I_1$ and $I_2$ are the magnitudes of induced current in the cases $I$ and $II$,respectively,then

The figure shown has two coils of wires placed in close proximity. The current in primary coil $P$ is made to vary with time as shown in the graph. Which of the following graphs best represents the variation of the emf induced in the secondary coil $S$?