A steel and a brass wire, each of length 50 , | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(B) Let $Y_s$ and $Y_b$ be the Young's modulus of steel and brass respectively. Given $Y_s = 2 	imes 10^{12} \,dynes/cm^{2}$ and $Y_b = 1 	imes 10^{

Vedclass · Accepted Answer

$5$

Vedclass · Answer

(B) Let $Y_s$ and $Y_b$ be the Young's modulus of steel and brass respectively. Given $Y_s = 2 	imes 10^{12} \,dynes/cm^{2}$ and $Y_b = 1 	imes 10^{12} \,dynes/cm^{2}$.Let $L = 50 \,cm$ be the length, $A = 0.005 \,cm^{2}$ be the cross-sectional area, and $\Delta L = 0.1 \,cm$ be the extension for both wires.The tension $T$ in a wire is given by $T = \frac{Y A \Delta L}{L}$.Since $A, \Delta L,$ and $L$ are the same for both wires, the tension $T$ is directly proportional to the Young's modulus $Y$ $(T \propto Y)$.Let $T_s$ be the tension in the steel wire and $T_b$ be the tension in the brass wire.$T_s = \frac{Y_s A \Delta L}{L}$ and $T_b = \frac{Y_b A \Delta L}{L}$.Taking torque about the point where the load $W$ is applied at a distance $x$ from the steel wire:$T_s \cdot x = T_b \cdot (15 - x)$.Substituting the proportionality $T_s \propto Y_s$ and $T_b \propto Y_b$:$Y_s \cdot x = Y_b \cdot (15 - x)$.$(2 	imes 10^{12}) \cdot x = (1 	imes 10^{12}) \cdot (15 - x)$.$2x = 15 - x$.$3x = 15$.$x = 5 \,cm$.

Similar Questions

The dimensions of four wires of the same material are given below. The increase in length is maximum in the wire of

What is the Young's modulus and bulk modulus for a perfect rigid body?

$A$ meter scale of mass $m$,Young's modulus $Y$,and cross-sectional area $A$ is hung vertically from the ceiling at the zero mark. The separation between the $30\ cm$ and $70\ cm$ marks will be: (Assume $\frac{mg}{AY}$ is dimensionless)

When a rod is heated but prevented from expanding,the stress developed is independent of

Vedclass Test Series

Exam Paper Generator

Online Exam Module