Assume that a block of very low shear modulus is fixed on an inclined plane as shown. Due to elastic forces,it will deform. What will be the shape of the block?

Steel ruptures when a shear stress of $3.5 \times 10^8 \, N \, m^{-2}$ is applied. The force needed to punch a $1 \, cm$ diameter hole in a steel sheet $0.3 \, cm$ thick is nearly:

The upper end of a wire of diameter $12\,mm$ and length $1\,m$ is clamped and its other end is twisted through an angle of $30^{\circ}$. The angle of shear is $........^{\circ}$.

The ratio of lengths of two rods $A$ and $B$ of the same material is $1:2$ and the ratio of their radii is $2:1$. What is the ratio of the modulus of rigidity of $A$ and $B$ (in $:1$)?

$A$ square aluminium (shear modulus is $25 \times 10^{9} \, N m^{-2}$) slab of side $60 \, cm$ and thickness $15 \, cm$ is subjected to a shearing force (on its narrow face) of $18.0 \times 10^{4} \, N$. The lower edge is riveted to the floor. The displacement of the upper edge is $....... \mu m$.

$A$ force $F$ of the same magnitude is applied tangentially on the upper and lower faces of a cube in opposite directions. The side of the cube is $L$. The upper face of the cube shifts parallel to itself by a distance $x_{1}$. If another cube of the same material but with side $2L$ is subjected to the same condition,then the displacement of the top layer is: