If the interatomic spacing in a steel wire is $3.0 \mathring{A}$ and $Y_{\text{steel}} = 20 \times 10^{10} \text{ N/m}^2$, then the force constant is:

$A$ block of weight $100 \ N$ is suspended by copper and steel wires of same cross-sectional area $0.5 \ cm^2$ and lengths $\sqrt{3} \ m$ and $1 \ m$,respectively. Their other ends are fixed on a ceiling as shown in the figure. The angles subtended by the copper and steel wires with the ceiling are $30^{\circ}$ and $60^{\circ}$,respectively. If the elongation in the copper wire is $\Delta \ell_C$ and the elongation in the steel wire is $\Delta \ell_S$,then the ratio $\frac{\Delta \ell_C}{\Delta \ell_S}$ is. . . . . .
[Young's modulus for copper and steel are $1 \times 10^{11} \ N/m^2$ and $2 \times 10^{11} \ N/m^2$ respectively]

$A$ $0.1 \,kg$ mass is suspended from a wire of negligible mass. The length of the wire is $1 \,m$ and its cross-sectional area is $4.9 \times 10^{-7} \,m^2$. If the mass is pulled a little in the vertically downward direction and released, it performs simple harmonic motion of angular frequency $140 \,rad \,s^{-1}$. If the Young's modulus of the material of the wire is $n \times 10^9 \,N \,m^{-2}$, the value of $n$ is

Write the unit and dimensional formula of modulus of elasticity.

The density of a rubber cord is $d$. $A$ thick rubber cord of length $L$ and cross-sectional area $A$ undergoes elongation under its own weight when suspended vertically. This elongation is proportional to:

The lengths of four wires $A, B, C$ and $D$ made of the same material are $1 \,m, 2 \,m, 3 \,m$ and $4 \,m$ respectively. The radii of the wires $A, B, C$ and $D$ are $0.2 \,mm, 0.4 \,mm, 0.6 \,mm$ and $0.8 \,mm$ respectively. For the same applied tension, the elongation is more in which wire?