Resistance of a given wire is obtained by measuring the current flowing in it and the voltage difference applied across it. If the percentage errors in the measurement of the current and the voltage difference are $3\%$ each,then the error in the value of resistance of the wire is ........ $\%$

In an experiment to determine the acceleration due to gravity $g$,the formula used for the time period of a periodic motion is $T=2 \pi \sqrt{\frac{7(R-r)}{5 g}}$. The values of $R$ and $r$ are measured to be $(60 \pm 1) \text{ mm}$ and $(10 \pm 1) \text{ mm}$,respectively. In five successive measurements,the time period is found to be $0.52 \text{ s}, 0.56 \text{ s}, 0.57 \text{ s}, 0.54 \text{ s}$ and $0.59 \text{ s}$. The least count of the watch used for the measurement of time period is $0.01 \text{ s}$. Which of the following statement$(s)$ is(are) true?
$(A)$ The error in the measurement of $r$ is $10 \%$
$(B)$ The error in the measurement of $T$ is $3.57 \%$
$(C)$ The error in the measurement of $T$ is $2 \%$
$(D)$ The error in the determined value of $g$ is $11 \%$

The potential difference across the ends of a conductor is $(30 \pm 0.3) \ V$ and the current through the conductor is $(5 \pm 0.1) \ A$. The error in the determination of the resistance of the conductor is: (in $\%$)

$A$ packet contains silver powder of mass $20.23 \,g \pm 0.01 \,g$. Some of the powder of mass $5.75 \,g \pm 0.01 \,g$ is taken out from it. The mass of the powder left back is ................

The error in the measurement of force acting normally on a square plate is $3 \%$. If the error in the measurement of the side of the plate is $1 \%$, then the error in the determination of the pressure acting on the plate is (in $\%$)

Resistance of a rod is calculated by measuring its length with the help of a meter scale of least count $1 \ mm$. Its radius is measured with the help of a screw gauge having $50$ divisions on the circular scale and a pitch of $1 \ mm$. Resistivity of the material is exact. The length of the wire is found to be $20 \ cm$ and the diameter of the wire is $4 \ mm$. Find the percentage error in the calculation of resistance.