$A$ pump motor is used to deliver water at a certain rate from a given pipe. To obtain twice as much water from the same pipe in the same time, the power of the motor has to be increased to: (in $\times$)

Fill in the blanks:
$(i)$ The cohesive force between the molecules of liquid is more than the adhesive force between the molecules of the plate, then the angle of contact obtained is ...... (acute/obtuse) and the free surface has a shape of ...... (concave/convex).
$(ii)$ The cohesive force between the molecules of liquid is less than the adhesive force between the molecules of the plate, then the angle of contact obtained is ...... (acute/obtuse) and the free surface has a shape of ...... (concave/convex).
$(iii)$ $A$ large pressure is exerted on the surface of a liquid having a shape of .......... (concave/convex).

Fill in the blanks:
$(i)$ The lines of flow and streamlines coincide with each other in ...... flow.
$(ii)$ The formula for the horizontal velocity of water coming from a hole at the bottom at a height $h$ from the surface of the water is ......
$(iii)$ $1 \ Pa = ...... \ dyne/cm^{2}$
$(iv)$ The relative velocity of two parallel layers of water is $6 \ cm/s$. If the perpendicular distance between the two layers is $0.1 \ mm$,then the velocity gradient will be ......

The Karman line is a theoretical construct that separates the Earth's atmosphere from outer space. It is defined as the height at which the lift on an aircraft flying at the speed of a polar satellite $(8 \, km/s)$ is equal to its weight. Taking a fighter aircraft of wing area $30 \, m^2$ and mass $7500 \, kg$,the height of the Karman line above the ground will be in the range of .............. $km$. (Assume the density of air at height $h$ above the ground to be $\rho(h) = 1.2 e^{-h/10} \, kg/m^3$,where $h$ is in $km$,and the lift force to be $\frac{1}{2} \rho v^2 A$,where $v$ is the speed of the aircraft and $A$ is its wing area.)

$A$ large number of water drops,each of radius $r$,combine to form a single drop of radius $R$. If the surface tension is $T$ and the mechanical equivalent of heat is $J$,then the rise in temperature will be:

$A$ large number of droplets,each of radius $r$,coalesce to form a bigger drop of radius $R$. An engineer designs a machine so that the energy released in this process is converted into the kinetic energy of the drop. The velocity of the drop is ($T=$ surface tension,$\rho =$ density)