$A$ steel ring of radius $r$ and cross-sectional area $A$ is fitted onto a wooden disc of radius $R$ $(R > r)$. If Young's modulus is $Y$,then the force with which the steel ring is expanded is

$A$ thin rod having a length of $1\;m$ and area of cross-section $3 \times 10^{-6}\;m^2$ is suspended vertically from one end. The rod is cooled from $210^{\circ}C$ to $160^{\circ}C$. After cooling,a mass $M$ is attached at the lower end of the rod such that the length of the rod again becomes $1\;m$. Young's modulus and coefficient of linear expansion of the rod are $2 \times 10^{11}\;Nm^{-2}$ and $2 \times 10^{-5}\;K^{-1}$,respectively. The value of $M$ is $.......kg$. (Take $g=10\;ms^{-2}$)

The dimensions of four wires of the same material are given below. In which wire will the increase in length be maximum when the same tension is applied?

$A$ mild steel wire of length $2l$ meter and cross-sectional area $A \; m^2$ is fixed horizontally between two pillars. $A$ small mass $m \; kg$ is suspended from the midpoint of the wire. If the extension in the wire is within the elastic limit,then the depression $x$ at the midpoint of the wire will be:

$A$ steel rod with $Y = 2.0 \times 10^{11} \, N/m^2$ and $\alpha = 10^{-5} \, ^\circ C^{-1}$ of length $4 \, m$ and area of cross-section $10 \, cm^2$ is heated from $0^\circ C$ to $400^\circ C$ without being allowed to extend. The tension produced in the rod is $x \times 10^5 \, N$ where the value of $x$ is ....... .

Two wires each of radius $0.2\,cm$ and negligible mass, one made of steel and the other made of brass, are loaded as shown in the figure. The elongation of the steel wire is $.........\times 10^{-6}\,m$. [Young's modulus for steel $= 2 \times 10^{11}\,N/m^2$ and $g = 10\,m/s^2$]