Consider the situation shown in the figure. T | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(B) The induced electromotive force $(emf)$ in a moving conductor is given by $e = B l v$,where $B$ is the magnetic field,$l$ is the length of the con

Vedclass · Accepted Answer

Remain the same

Vedclass · Answer

(B) The induced electromotive force $(emf)$ in a moving conductor is given by $e = B l v$,where $B$ is the magnetic field,$l$ is the length of the conductor perpendicular to the velocity,and $v$ is the velocity.In this setup,the effective length $l$ of the wire that cuts the magnetic field lines is the distance between the two rails (the chord length of the wire).When the straight wire $AB$ is replaced by a semicircular wire with the same chord length,the effective length $l$ remains unchanged because the distance between the points of contact on the rails remains the same.Since $e = B l v$,and $B, l,$ and $v$ remain constant,the induced $emf$ remains the same.Consequently,the induced current $I = e / R$ also remains the same,assuming the resistance $R$ of the circuit does not change.

Consider the situation shown in the figure. The wire $AB$ is sliding on the fixed rails with a constant velocity $v$. If the wire $AB$ is replaced by a semicircular wire of the same chord length,the magnitude of the induced current will

Similar Questions

Two concentric coils of $10$ turns each are placed in the same plane. Their radii are $20 \ cm$ and $40 \ cm$ and carry $0.2 \ A$ and $0.3 \ A$ current respectively in opposite directions. The magnetic induction (in $T$) at the centre is

$A$ lift is moving downwards with an acceleration equal to the acceleration due to gravity. $A$ body of mass $M$ kept on the floor of the lift is pulled horizontally. If the coefficient of friction is $\mu$,then the frictional resistance offered by the body is:

Polysaccharides have .............. linkage?

The equations $x-y=4$ and $x^2+4xy+y^2=0$ represent the sides of a/an

$A$ sonometer wire has a length of $114 ~cm$ between two fixed ends. Where should two bridges be placed so as to divide the wire into three segments (in $cm$) whose fundamental frequencies are in the ratio $1:3:4$?

Vedclass Test Series

Exam Paper Generator

Online Exam Module