The figure below shows a particular position of the Vernier calipers on a centimetre scale. In this position,the value of $x$ shown in the figure is .......... $cm$ (figure is not to scale).

In a vernier callipers,$10$ divisions of vernier scale coincide with $9$ divisions of main scale. One division of main scale is of $0.1 \ cm$. If in the measurement of inner diameter of a cylinder,the zero of the vernier scale lies between $1.3 \ cm$ and $1.4 \ cm$ of the main scale and the $2^{\text{nd}}$ division of the vernier scale coincides with a main scale division,then the diameter will be: (in $cm$)

The least count of a screw gauge is $0.01 \ mm$. If the pitch is increased by $75\%$ and the number of divisions on the circular scale is reduced by $50\%$,the new least count will be . . . . . . $\times 10^{-3} \ mm$.

In a Vernier Calipers,$10$ divisions of the Vernier scale are equal to $9$ divisions of the main scale. When both jaws of the Vernier calipers touch each other,the zero of the Vernier scale is shifted to the left of the zero of the main scale,and the $4^{\text{th}}$ Vernier scale division exactly coincides with a main scale division. One main scale division is equal to $1\,mm$. While measuring the diameter of a spherical body,the body is held between the two jaws. It is observed that the zero of the Vernier scale lies between $30$ and $31$ divisions of the main scale,and the $6^{\text{th}}$ Vernier scale division exactly coincides with a main scale division. The diameter of the spherical body is $.......\,cm$.

$A$ student measured the diameter of a small steel ball using a screw gauge of least count $0.001 \, cm$. The main scale reading is $5 \, mm$ and the circular scale division coinciding with the reference level is $25$. If the screw gauge has a zero error of $-0.004 \, cm$,the correct diameter of the ball is: (in $, cm$)

The main scale division of a vernier caliper is $1 \ mm$. The vernier scale divisions are in an arithmetic progression $(A.P.)$; the $1^{st}$ division is $0.95 \ mm$, the $2^{nd}$ division is $0.90 \ mm$, and so on. When an object is placed between the jaws of the vernier caliper, the zero of the vernier scale lies between $3.1 \ cm$ and $3.2 \ cm$, and the $4^{th}$ division of the vernier scale coincides with a main scale division. The reading of the vernier caliper is .......... $cm$.