The percentage error in the calculated volume of a sphere, if there is $2\%$ error in its diameter measurement, is . . . . . . .

The maximum error in the measurement of resistance,current,and time for which current flows in an electrical circuit are $1 \%$,$2 \%$,and $3 \%$ respectively. The maximum percentage error in the calculation of the dissipated heat will be (in $\%$)

The density $\rho$ of a uniform cylinder is determined by measuring its mass $m$, length $l$ and diameter $d$. The measured values of $m, l$ and $d$ are $97.42 \pm 0.02 \text{ g}$, $8.35 \pm 0.05 \text{ mm}$ and $20.20 \pm 0.02 \text{ mm}$, respectively. The calculated percentage fractional error in $\rho$ is . . . . . . . (in $\%$)

If the error in measuring the diameter of a circle is $4\%$,the error in the circumference of the circle would be (in $\%$)

In the measurement of a physical quantity $X = \frac{A^2 B}{C^{1/3} D^3}$, the percentage errors introduced in the measurements of the quantities $A, B, C$, and $D$ are $2 \%, 2 \%, 4 \%$, and $5 \%$, respectively. Then, the minimum amount of percentage error in the measurement of $X$ is contributed by:

If the length of rod $A$ is $3.25 \pm 0.01 \,cm$ and that of rod $B$ is $4.19 \pm 0.01 \,cm$,then the rod $B$ is longer than rod $A$ by: