Which of the following is NOT a reason for wh | vedclass

Name: Exam Paper Generator | JEE NEET Paper Generator | Vedclass
Brand: Vedclass
Rating: 5 (35 reviews)

Question

(B) Modulation is primarily used for three reasons: $1$. To reduce the size of the antenna: An antenna size should be of the order of $\lambda/4$. For

Vedclass · Accepted Answer

To reduce the time interval between the transmitter and the receiver.

Vedclass · Answer

(B) Modulation is primarily used for three reasons: $1$. To reduce the size of the antenna: An antenna size should be of the order of $\lambda/4$. For low-frequency audio signals,$\lambda$ is very large,requiring an impractically large antenna. Modulation shifts the signal to a higher frequency,reducing $\lambda$ and thus the antenna size. $2$. To reduce the fractional bandwidth: The ratio of signal bandwidth to carrier frequency is reduced,which makes the design of the antenna and the tuning circuit easier. $3$. To allow for multiplexing: By modulating different signals to different carrier frequencies,multiple signals can be transmitted simultaneously over the same channel. Option $B$ is incorrect because modulation does not reduce the time interval (propagation delay) between the transmitter and receiver; this is determined by the speed of the signal (usually the speed of light) and the distance between them.

Which of the following is $NOT$ a reason for why we need modulation in communication systems?

Similar Questions

$A$ layer of the atmosphere that reflects medium-frequency radio waves and is ineffective during the night is

$A$ transmitting antenna at the top of a tower has a height of $50\, m$ and the height of the receiving antenna is $80\, m$. What is the range of communication for Line of Sight (LoS) mode? (In $km$)
[Use radius of earth $R = 6400\, km$]

In amplitude modulation,the amplitude of the carrier wave is $A_c$ and that of the modulating signal is $A_m$. In practice,the ratio of $A_m$ to $A_c$ is kept less than or equal to $1$ to avoid:

$A$ $..........$ is used in the receiver section to reduce the magnitude of signals.

The characteristic impedance of a coaxial cable is of the order of .......... $\Omega$.

Vedclass Test Series

Exam Paper Generator

Online Exam Module