The least count of the main scale of a screw gauge is $1\, mm$. The minimum number of divisions on its circular scale required to measure $5\,\mu m$ diameter of a wire is

The main scale of a vernier calliper has $n$ divisions per $cm$. $n$ divisions of the vernier scale coincide with $(n-1)$ divisions of the main scale. The least count of the vernier calliper is,

Diameter of a steel ball is measured using a Vernier callipers which has divisions of $0.1\,cm$ on its main scale $(MS)$ and $10$ divisions of its vernier scale $(VS)$ match $9$ divisions on the main scale. Three such measurements for a ball are given as:

$S$.No.	$MS\;(cm)$	$VS$ divisions
$(1)$	$0.5$	$8$
$(2)$	$0.5$	$4$
$(3)$	$0.5$	$6$

If the zero error is $-0.03\,cm,$ then the mean corrected diameter is ........... $cm$.

The internal and external radii of a hollow cylinder are measured with the help of a vernier callipers. Their values are $(4.23 \pm 0.01) \, cm$ and $(3.87 \pm 0.01) \, cm,$ respectively. The thickness of the wall of the cylinder is

$A$ screw gauge has a pitch of $1.5\; mm$ and there is no zero error. The linear scale has markings at $MSD = 1\; mm$ and there are $100$ equal divisions on the circular scale. When the diameter of a sphere is measured with this instrument,the $2\; mm$ mark is visible on the linear scale,but the $3\; mm$ mark is not visible. The $76^{th}$ division of the circular scale is in line with the linear scale. What is the diameter of the sphere in $mm$?

$A$ student measured the length of a rod and wrote it as $3.50\;cm$. Which instrument did he use to measure it?