The balancing length for a cell is $560 \, cm$ in a potentiometer experiment. When an external resistance of $10 \, \Omega$ is connected in parallel to the cell, the balancing length changes by $60 \, cm$. The internal resistance of the cell in ohms, is

$A$ potentiometer has a uniform potential gradient across it. Two cells connected in series $(i)$ to support each other and $(ii)$ to oppose each other are balanced over $6 \ m$ and $2 \ m$ respectively on the potentiometer wire. The ratio of the $e.m.f.$s of the cells is:

When a potentiometer is connected between the points $A$ and $B$ as shown in the circuit,the balance point is obtained at $64 \ cm$. When it is connected between $A$ and $C$,the balance point is $8 \ cm$. If the potentiometer is connected between $B$ and $C$,the balance point will be: (in $cm$)

The length of a wire of a potentiometer is $100 \, cm$,and the $emf$ of its standard cell is $E \, volt$. It is employed to measure the $emf$ of a battery whose internal resistance is $0.5 \, \Omega$. If the balance point is obtained at $l = 30 \, cm$ from the positive end,the $emf$ of the battery is (where $i$ is the current in the potentiometer wire).

In the given figure,a battery $E$ is balanced on $55 \, cm$ length of a potentiometer wire. When a resistance of $10 \, \Omega$ is connected in parallel with the battery,it balances on $50 \, cm$ length of the potentiometer wire. The internal resistance $r$ of the battery is ............. $\Omega$.

In the given potentiometer circuit arrangement,the balancing length $AC$ is measured to be $250 \, cm$. When the galvanometer connection is shifted from point $(1)$ to point $(2)$ in the given diagram,the balancing length becomes $400 \, cm$. The ratio of the emf of two cells,$\frac{\varepsilon_{1}}{\varepsilon_{2}}$ is -